Trundles Heavy Duty Green Tow Point (Pair) to suit Isuzu D-Max 2012-2020
Trundles Heavy Duty Green Tow Point (Pair) to suit Isuzu D-Max 2012-2020
Click image to open expanded view
Trundles Heavy Duty Green Tow Point (Pair) to suit Isuzu D-Max 2012-2020
Trundles Heavy Duty Green Tow Point (Pair) to suit Isuzu D-Max 2012-2020

Trundles Heavy Duty Green Tow Point (Pair) to suit Isuzu D-Max 2012-2020

Price
$399
Usually Ships Within 24 Hours, Unless on Pre-Order

Trundles Heavy Duty Green Tow Point (Pair) to suit Isuzu D-Max 2012-2020

Includes:
1x Pair of Heavy Duty Tow Points - RP-COL02V2

Details:
- Made from 10mm Plate Steel
- Using SS41 carbon steel plate (Q235)
- Direct bolt on to your chassis
- No cutting or welding required
- Sold as a pair
- Option of using a Bridle strap
- Powdercoated Green for High visibility
- Destruction tested to over 100.4kN (10.23 ton force) EACH
- Each component will be rated to a WLL (Working Load Limit) of 3250kgs
- Only to be used with a shackle rated to maximum 3.25t.

Fits the following Bullbars:
ARB, ARB SUMMIT BAR, ECB, IRONMAN , FACTORY BUMPER, FACTORY NUDGE BAR (Refer comments), TJM - WITH MODIFICATIONS, OPPOSITE LOCK, GENUINE BULLBAR, LEGENDEX BULLBAR

More Information:
A must have for anyone considering any type of off road or remote touring. The factory tow points are no better than a tie down point for transport. These Recovery points will allow you to use a Bridle strap to ensure an even tow.

Fitting Issues:
-Does not suit post 2017 facelift models at this stage

-ARB Summit Bar requires 2 longer than what's supplied with the RP-COL02 - refer to imagery

-Ironman requires modification - Cut the lower return off from the Bull bar mount Drill new 12mm hole between 2 vertical holes Manufacture new tab to mount protection plates The current points can be modified to fit, however if modified they will not be covered by the rating applied. The new design will be tested with these modifications.

-TJM - Modifications required, trim bull bar gussets back 20mm to allow fitment of tow point flush against chassis.

-Factory Nudge Bar fitting requires removal of nudge bar, install RP-COL02 per instructions, and refit nudge bar.

-Legendex - discard L shaped packers, and factory bash plate will need trimming

Note: If you require the fitting guide for this item, please click here

Disclaimer: It is the purchaser’s responsibility to ensure all products and the installation thereof meet current LVV requirements, where applicable.

Vehicle Fitment
SKU
RP-COL02V2

You may also like