Trundles 40-75mm Adjustable MG Front Lift Kit to suit Nissan Navara D23 NP300 (Coil Rear) 2015-Onwards

Trundles 40-75mm Adjustable MG Front Lift Kit to suit Nissan Navara D23 NP300 (Coil Rear) 2015-Onwards

Note:
- A 100mm Lift is achievable with extra components. A 100mm Lift will most likely NOT pass a NZ certification as this will decrease the suspension droop travel, it is up to the customer to set these any higher than a 75mm Lift.

Looking for a quick and easy lift for your D23 Navara? We have the answer!

Simply unbolt your factory struts and replace with these direct bolt-in front pre-assembled shocks.

Please use the drop down menu to select your lift amount and the correct spring rates depending on your vehicles accessories.

Type: Navara
Model: D23 NP300
Year: 08/2014 -
Suspension Type: Coil Spring Front / Coil Spring Rear
Front Lift: Factory Height - 40mm Lift
Detail: 
- 4x4 Single Cab / Dual Cab / Extra Cab Models
- Monotube Internal Reservoir Shock Absorbers
- These front struts are pre-assembled in our workshop and ready to go.

Front:
2x Profender Adjustable Coil-Over Shocks
1x Pair Dobinsons Front Springs
2x Trundles Strut Mounts
1x Pair Trundles Upper Control Arms
1x Pair Front Sway Bar Links

40-75mm (2-3") Lifts with 410-415mm Extended Length shocks will give up to 600mm Hub-To-Guard height and will clear the strut tower without issues in most cases.

Profender front shocks for IFS vehicles are supplied with spring seat spacers (collars). These collars fit beneath the spring seat and can be used to increase spring preload and vehicle ride height if additional lift is required in the future.
 
When you order a pre-assembled strut from us, you do not need to install these collars before fitting the strut. Your struts are assembled to your requested ride height and load rating using a correctly specified coil spring.
 
If you are ordering shocks only to use with an existing lifted coil spring, you also do not need to install the collars, provided your current springs are correctly specified.
 
Installing these collars will increase the ride height of your supplied strut. As a guide, the 10 mm collar will typically provide approximately 15 mm of additional vehicle lift, although actual lift will vary depending on vehicle weight, accessories, and spring rate.
 
The collars are supplied separately and are not required for standard installation.
 
New Zealand Compliance Notice: If these collars are fitted to alter the spring seat height and increase ride height, LVV certification will be required before the vehicle can be legally used on the road. Customers should consult an LVV certifier before installation.
 
Shocks installed without the spring seat spacers are generally treated as direct replacement suspension components and typically do not require LVV certification.