Profender 75mm MG Lift Kit to suit Nissan Navara D23 NP300 (Coil Rear) 2015-Onwards

Profender 75mm MG Lift Kit to suit Nissan Navara D23 NP300 (Coil Rear) 2015-Onwards

Note:
-The NP300 sits nose down from factory, therefore if you are chasing an even look we recommend only raising the rear 40mm only
-Series 5 May Require Notching Of The Lower Trailing Arm to Allow MRR To Fit

Please use the drop down menu to select your correct spring rates depending on your vehicles accessories.

Type: Navara
Model: D23 NP300 
Year: 2015 -
Suspension Type: Coil Spring Front / Coil Spring Rear
Front Lift: 75mm Lift
Rear Lift: 40-75mm Lift
Detail:
- Series 5 Long Wheelbase Models Only
- 4x4 Single Cab / Dual Cab / Extra Cab Models
- Monotube Internal Reservoir Shock Absorbers
- Front shocks come pre-assembled for ease of installation.

Front
2x Profender Adjustable Coil-Over Shocks - MG-56110A100
1x Pair Dobinsons Front Springs
2x Trundles Strut Mounts - TOP7
1x Pair Trundles Upper Control Arms - UCA4981NV2
1x Pair Trundles Extended Front Sway Bar Links - NAV-033LH & NAV-033RH

Rear (40mm Lift Options)
2x Profender Gas Rear Shocks - PF-5009P
1x Pair Dobinsons Rear Coil Springs

Rear (75mm Lift Options)
2x Profender Gas Rear Shocks - PF-5009P
1x Pair Dobinsons Rear Coil Springs
2x Trundles Rear Extended Sway Bar Links - NAV-031
1x Trundles Adjustable Panhard Rod - NAV-032
1x Trundles Adjustable Headlight Bracket - NAV-026
1x Set Trundles Rear Brake Hoses - EBH-NP300-R-R

75-100mm (3-4") Lifts with 420-425mm Extended Length shocks will give up to 620mm Hub-To-Guard height but will require clearancing of the strut tower. 

These lifts will result in a higher CV angle and may require more alignment correction components and the potential of reduced ride comfort.

Profender front shocks for IFS vehicles are supplied with spring seat spacers (collars). These collars fit beneath the spring seat and can be used to increase spring preload and vehicle ride height if additional lift is required in the future.
 
When you order a pre-assembled strut from us, you do not need to install these collars before fitting the strut. Your struts are assembled to your requested ride height and load rating using a correctly specified coil spring.
 
If you are ordering shocks only to use with an existing lifted coil spring, you also do not need to install the collars, provided your current springs are correctly specified.
 
Installing these collars will increase the ride height of your supplied strut. As a guide, the 10 mm collar will typically provide approximately 15 mm of additional vehicle lift, although actual lift will vary depending on vehicle weight, accessories, and spring rate.
 
The collars are supplied separately and are not required for standard installation.
 
New Zealand Compliance Notice: If these collars are fitted to alter the spring seat height and increase ride height, LVV certification will be required before the vehicle can be legally used on the road. Customers should consult an LVV certifier before installation.
 
Shocks installed without the spring seat spacers are generally treated as direct replacement suspension components and typically do not require LVV certification.