Profender Monotube Adjustable Front Coilovers (Pair) to suit Holden Colorado RG 2012-2020

Profender Monotube Adjustable Front Coilovers (Pair) to suit Holden Colorado RG 2012-2020

Includes:
2x Monotube Adjustable Shock Absorbers - MG-9610A50
4x Spring Seat Spacers - see below "Included Spring Seat Spacers" section for more details 
2x Removable Spring Seats

Details:
- These shocks are suitable for 45mm-100mm Lift. They will come pre-set at approximately 75mm - any fine adjustments can be done by customer after test fitting
- These shocks are fully rebuildable and can be re-valved
- Fine adjustments can still be made by filling up or releasing Nitrogen in the shock body instead of the reservoir
- 1 Year Manufacturer Warranty

Measurements:
- Min. Pressure 80 PSI
- Max. Pressure 200 PSI
- Pressure Set From Factory 150 PSI
- 46mm Piston with Teflon
- 20mm Super Polished Shaft
- 53mm Outer Body 

Extended & Compressed Lengths:
- Extended Length - 510mm (Pin Base to Eye Centre)
- Compressed Length - 354mm (Pin Base to Eye Centre)

Note: You must use a ball joint spacer or UCA with this front lift kit to achieve more than 40mm of Lift - Please See Ball Joint Spacers HERE

Please note as these are a Height Adjustable Coilover Strut, they require LVVTA Certification.

Profender front shocks for IFS vehicles are supplied with spring seat spacers (collars). These collars fit beneath the spring seat and can be used to increase spring preload and vehicle ride height if additional lift is required in the future.
 
When you order a pre-assembled strut from us, you do not need to install these collars before fitting the strut. Your struts are assembled to your requested ride height and load rating using a correctly specified coil spring.
 
If you are ordering shocks only to use with an existing lifted coil spring, you also do not need to install the collars, provided your current springs are correctly specified.
 
Installing these collars will increase the ride height of your supplied strut. As a guide, the 10 mm collar will typically provide approximately 15 mm of additional vehicle lift, although actual lift will vary depending on vehicle weight, accessories, and spring rate.
 
The collars are supplied separately and are not required for standard installation.
 
New Zealand Compliance Notice: If these collars are fitted to alter the spring seat height and increase ride height, LVV certification will be required before the vehicle can be legally used on the road. Customers should consult an LVV certifier before installation.
 
Shocks installed without the spring seat spacers are generally treated as direct replacement suspension components and typically do not require LVV certification.